// ENGINE MANAGEMENT · ELECTRONICS · CAN SYSTEMS

Race
Condition

The only race condition you actually want in your garage.

Integration, calibration, and diagnostics of engine management systems, electronics, and CAN connected devices — plus 3D scanning and prototyping. From the street to the drag strip to the road course.

Get in touch What we do

0x7E0 [8] 02 01 0C 55 55 55 55 55 · RPM 7 4 0 0 · 0x316 [8] 0D 1F 3C 00 8A 00 00 00 · ECT 92°C · 0x545 [8] 00 00 4E 20 00 00 00 00 · MAP 1.8 bar · 60FT 1.42s · 0x1F0 [8] 13 37 00 C0 FF EE 00 01 · LAMBDA 0.85 · 0x6F1 [8] 12 04 71 01 00 00 00 00 · UDS SESSION 0x03 · 0x7DF [8] 02 09 02 00 00 00 00 00 · VIN REQ · 0x7E0 [8] 02 01 0C 55 55 55 55 55 · RPM 7 4 0 0 · 0x316 [8] 0D 1F 3C 00 8A 00 00 00 · ECT 92°C · 0x545 [8] 00 00 4E 20 00 00 00 00 · MAP 1.8 bar · 60FT 1.42s · 0x1F0 [8] 13 37 00 C0 FF EE 00 01 · LAMBDA 0.85 · 0x6F1 [8] 12 04 71 01 00 00 00 00 · UDS SESSION 0x03 · 0x7DF [8] 02 09 02 00 00 00 00 00 · VIN REQ ·

// services

Four disciplines. One clean run.

STAGE 01 — INTEGRATION

Integration

Standalone and OEM engine management fitted, wired, and talking to the rest of the car. Harness design, sensor selection, gateway and module integration — everything on the bus, nothing fighting for it.

STAGE 02 — CALIBRATION

Calibration

Fueling, ignition, boost, launch and torque strategies mapped on the dyno and validated at the strip and on track. Clean, repeatable calibrations with full logs — power you can trust pass after pass, lap after lap.

STAGE 03 — DIAGNOSTICS

Diagnostics

CAN bus tracing, module fault isolation, intermittent electrical gremlins, and data-driven root cause analysis. We read the frames, not the guesswork.

STAGE 04 — SCANNING & PROTOTYPING

3D Scanning & Prototyping

3D scanning and prototype design — engine bays, brackets, and factory parts captured as precise digital models, then developed into prototype designs and print-ready files for your 3D printer or fabricator.

// capabilities

Built for race day

Motorsport-grade process applied to every build: version-controlled calibrations, documented wiring, and full data logs handed over with the keys.

Standalone ECU installation & setup
OEM ECU calibration & flashing
CAN / CAN-FD network design & tracing
UDS & OBD-II diagnostics
Motorsport wiring harnesses
Dash, logger & PDM configuration
Dyno tuning & track support
Drag racing setup & launch control
Sensor integration & validation
Module retrofits & coding
3D scanning & reverse engineering
CAD design & prototyping
3D print-ready part design
Data analysis & telemetry

// contact

Lights out and
away we go.

[email protected]

Based in Indiana — serving the greater Indianapolis area. Will travel for track and event support.

RaceCondition